The next steps depend on the phone boot version. The handset display will remain blank. If the phone powers on before Repair procedure completes, repeat whole operation from the beginning. Pickup correct model from the scrolling list. Phone doesn’t have to turn on! At this time popup window appears at SmartMoto interface.
|Date Added:||23 April 2006|
|File Size:||67.35 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The phone may not accept unlock code if the wrong unlock code was entered too many times and Wrong Code S flash neptune lte2 is filled. No need to perform a Clip Login to access TP pictures. Alternatively, the handset can be neeptune using a TestPoint method. In this case try performing “Master reset” operation and then enter the code again.
To install the driver: After that log to bookmark “Flash”, s flash neptune lte2 “Enter flash mode” and continue clash the step Reserve copy of security area is created. SmartMoto will give the message requiring to take phone into boot mode by pressing keys combination: The Smart TestPoint v2.
The handset restarts and can be disconnected. Part of phone firmware ,te2 reflashed. Please make sure you do not damage the board We strictly recommend to make a backup of flash from the handset before performing any procedure.
Specific procedures for each model are provided blow.
Please follow this order strictly. Some phone models require a particular procedure to be performed while using “Unlock via TestPoint” method. This can seriously damage s flash neptune lte2 handset. Make sure that phone model and boot version of the phone to be unlocked exactly match the model nptune boot version stated in the list.
SmartMoto Unlocking Manual. Smart-Clip is a professional device for unlocking cell phones.
Follow the instructions in the schedule, please. In this case, after Prepare process is completed, the handset must be flashed with flash file and user data will be erased from the memory. Press “Enter flash mode”. No need to install s flash neptune lte2 phone model driver. If the phone powers on before Repair procedure completes, repeat whole operation from the beginning.
Alternatively use “Automatic Model Detection” option it will recognize phone automatically.
In most cases TP contacts neptue s flash neptune lte2 by a metal cover, which has to be cut or drilled for TestPoint procedure. The phone enters a flash mode continue with the step 14, please. Do not use power from the battery. Remove the battery from the phone as soon as reboot procedure starts.
However, in case of any hardware s flash neptune lte2 or phone warranty termination caused by TestPoint procedure Smart-Clip developer does not bear any responsibility. Phone goes into boot mode. TestPoint schematics are located at S flash neptune lte2 Downloads section of www. Models with boot versions up to 0. This will enable you to restore the handset to its original state in case of unlock process failure. The handset should be detected by SmartMoto as “S Blank If the set stays in Flash mode, phone model has to be selected manually.
Wait till the process finishes. Log to bookmark “Unlock”. Unmark nepfune “Unlock automatically after prepare” and select the appropriate model from SmartMoto list.
Log to “Flash” tab. A C38x Cx E6 E Please disconnect the phone from the cable, remove and insert the battery, switch the phone to boot mode and perform unlock s flash neptune lte2. Make sure that phone model exactly matches the model stated in the list.
SmartMoto is a flashing, repairing and unlocking software meant to be used with Clash and S-Card dongle. Please remember s flash neptune lte2 update Smart-Clip first and perform S-Card update after that only.
Use any other alternative tool to cut or drill it. At this time popup window appears at SmartMoto interface. Please note that the phone shouldn’t power on until the last stage flxsh. After the first Smart-Clip update and account registration at www.
Pickup correct model from the scrolling list.
Log to bookmark “Prepare”.